OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd reachable-time

Sets the advertised time for which the router sees a neighbor to be up after it receives a reachability confirmation.

Syntax
ipv6 nd reachable-time milliseconds
Parameters
  • reachable-time milliseconds — Enter the reachable time in milliseconds (0 to 3600000).
Defaults
0
Command Mode
INTERFACE
Usage Information
The no version of this command restores the default reachable time. 0 indicates that no reachable time is sent in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd reachable-time 1000
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\