OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd retrans-timer

Sets the time between retransmitting neighbor solicitation messages.

Syntax
ipv6 nd retrans-timer seconds
Parameters
  • retrans-timer seconds — Enter the retransmission time interval in milliseconds (100 to 4292967295).
Defaults
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command disables the configured retransmission timer.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd retrans-timer 1000
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\