OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 nd send-ra

Enables the sending of ICMPv6 Router Advertisement messages.

Syntax
ipv6 nd send-ra
Parameters
None
Defaults
RA messages are disabled.
Command Mode
INTERFACE
Usage Information
  • Using ICMPv6 Router Advertisement messages, the Neighbor Discovery protocol advertises the IPv6 addresses of IPv6-enabled interfaces and learns of any address changes in IPv6 neighbors. Before you enable sending RA messages, the switch must be in Router mode with IPv6 forwarding enabled and stateless autoconfiguration disabled ( no ipv6 address autoconfig command).
  • The no ipvd nd send-ra command disables RA messages.
Example
OS10(config)# interface ethernet 1/2/3
                                       OS10(conf-if-eth1/2/3)# ipv6 nd send-ra
                                    
Supported Releases
10.4.0E(R1) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\