OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 ospf cost

Changes the cost associated with the OSPFv3 traffic on an interface

Syntax
ipv6 ospf cost cost
Parameters
cost — Enter a value as the OSPFv3 cost for the interface (1 to 65335).
Default
Based on bandwidth reference
Command Mode
INTERFACE
Usage Information
If not configured, the interface cost is based on the auto-cost command. This command configures OSPFv3 over multiple vendors to ensure that all routers use the same cost value. The no version of this command removes the IPv6 OSPF cost configuration.
Example
OS10(config)# interface vlan 10
                                       OS10(conf-if-vl-10)# ipv6 ospf cost 10
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\