OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 ospf passive

Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface.

Syntax
ipv6 ospf passive
Parameters
None
Default
Not configured
Command Mode
INTERFACE
Usage Information
You must configure the interface before setting the interface to passive mode. The no version of the this command disables the Passive interface configuration.
Example
OS10(config)# interface ethernet 1/1/6
                                       OS10(conf-if-eth1/1/6)# ipv6 ospf passive
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\