OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 ospf priority

Sets the priority of the interface to determine the designated router for the OSPFv3 network.

Syntax
ipv6 ospf priority number
Parameters
number — Enter a router priority number (0 to 255).
Default
1
Command Mode
INTERFACE
Usage Information
When two routers attached to a network attempt to become the designated router, the one with the higher router priority takes precedence. The no version of this command resets the value to the default.
Example
OS10(config)# interface ethernet 1/1/6
                                       OS10(conf-if-eth1/1/6)# ipv6 ospf priority 4
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\