OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ipv6 route

Configures a static IPv6 static route.

Syntax
ipv6 route ipv6–prefix mask { next-hop | interface interface-type [ route-preference]}
Parameters
  • ipv6-prefix — Enter the IPv6 address in x:x:x:x::x format
  • mask — Enter the mask in slash prefix-length format (/x)
  • next-hop — Enter the next-hop IPv6 address in x:x:x:x::x format.
  • interface interface-type — Enter the interface type then the slot/port or number information. The interface types supported are: Ethernet, port-channel, VLAN , and Null.
  • route-preference — (Optional) Enter a route-preference range (1 to 255).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
  • When the interface fails, the system withdraws the route. The route reinstalls when the interface comes back up. When a recursive resolution is broken, the system withdraws the route. The route reinstalls when the recursive resolution is satisfied. After you create an IPv6 static route interface, if you do not assign an IP address to a peer interface, you must manually ping the peer to resolve the neighbor information.
  • The no version of this command deletes the IPv6 route configuration.
Example
OS10(config)# ipv6 route 2111:dddd:0eee::22/128 2001:db86:0fff::2
OS10(config)# ipv6 route 2111:dddd:0eee::22/128 interface null 0
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\