OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

iscsi enable

Enables iSCSI auto-detection of attached storage arrays and switch auto-configuration.

Syntax
iscsi enable
Parameter
None
Default
Enabled on S4048T-ON/S4048-ON; disabled on others
Command Mode
CONFIGURATION
Usage Information
iSCSI optimization automatically detects storage arrays and auto-configures switch ports with the iSCSI parameters received from a connected device. The no version of this command disables iSCSI auto-detection.
Example
OS10(config)# iscsi enable
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\