OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

iscsi profile-storage

Configures a port for direct connection to a storage device that is not automatically detected by iSCSI.

Syntax
iscsi profile-storage storage-device-name
Parameter
storage-device-name — Enter a user-defined name of a storage array that iSCSI does not automatically detect.
Default
Not configured
Command Mode
INTERFACE
Usage Information
Configure directly attached storage arrays to be supported by iSCSI if they are not automatically detected. This command is required for storage devices that do not support LLDP. The no version of this command disables the connection.
Example
OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\