OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

iscsi target port

Configures the TCP ports used to monitor iSCSI sessions with target storage devices.

Syntax
iscsi target port tcp-port1 [ tcp-port2, ..., tcp-port16] [ip-address ip-address]
Parameters
  • tcp-port — Enter one or more TCP port numbers (0 to 65535). Separate TCP port numbers with a comma.
  • ip-address ip-address — (Optional) Enter the IP address in A.B.C.D format of a storage array whose iSCSI traffic is monitored on the TCP port.
Default
3260,860
Command Mode
CONFIGURATION
Usage Information
You can configure up to 16 TCP ports to monitor iSCSI traffic from target storage devices. The no version of this command including the IP address removes a TCP port from iSCSI monitoring.
Example
OS10(config)# iscsi target port 26,40
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\