OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lacp port-priority

Sets the priority for the physical interfaces for LACP.

Syntax
lacp port-priority priority
Parameters
priority — Enter the priority for the physical interfaces (0 to 65535).
Default
32768
Command Mode
INTERFACE
Usage Information
LACP uses the port priority with the port number to create the port identifier. The port priority decides which ports are put into Standby mode when there is a hardware limitation that prevents all compatible ports from aggregating, or when you have more than eight ports configured for the channel group. When setting the priority, a higher number means a lower priority. The no version of this command returns the port priority to the default value.
Example
OS10(conf-range-eth1/1/7-1/1/8)# lacp port-priority 32768
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\