OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lacp rate

Sets the rate at which LACP sends control packets.

Syntax
lacp rate {fast | normal}
Parameters
  • fast — Enter the fast rate of 1 second.
  • normal — Enter the default rate of 30 seconds.
Default
30 seconds
Command Mode
INTERFACE
Usage Information
Change the LACP timer rate to modify the duration of the LACP timeout. The no version of this command resets the rate to the default value.
Example
OS10(conf-range-eth1/1/7-1/1/8)# lacp rate fast
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\