OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lacp system-priority

Sets the system priority of the device for LACP.

Parameters
priority — Enter the priority value for physical interfaces (0 to 65535).
Default
32768
Command Mode
CONFIGURATION
Usage Information
Each device that runs LACP has an LACP system priority value. LACP uses the system priority with the MAC address to form the system ID and also during negotiation with other systems. The system ID is unique for each device. The no version of this command resets the system priority to the default value.
Example
OS10(config)# lacp system-priority 32768
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\