OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

LED settings

Beacon LEDs enable to identify the location of ports and system with blinking or glowing LEDs.

Change current state of the location LED of the system or interface using the following commands:

location-led system {
                                 node-id | node-id/unit-id} {on | off}
                              
location-led interface ethernet {
                                 chassis/slot/port[:subport]} {on | off}
                                 
                              

Change the state of system location LED

OS10# location-led system 1 on
                                 OS10# location-led system 1 off
                              

Change the state of interface location LED

OS10# location-led interface ethernet 1/1/1 on
                                 OS10# location-led interface ethernet 1/1/1 off
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\