OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

link-bundle-utilization trigger-threshold

Configures a threshold value to trigger monitoring of traffic distribution on an ECMP link bundle.

Syntax
link-bundle-trigger-threshold value
Parameters
value — Enter a link bundle trigger threshold value (0 to 100).
Defaults
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command disables the configuration.
Example
OS10(config)# link-bundle-trigger-threshold 80
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\