OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp med fast-start-repeat-count

Configures the number of packets sent during the activation of the fast start mechanism.

Syntax
lldp-med fast-start-repeat-count number
Parameters
number — Enter the number of packets sent during the activation of the fast start mechanism (1 to 10).
Default
3
Command Mode
CONFIGURATION
Usage Information
None
Example
OS10(config)# lldp med fast-start-repeat-count 5
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\