OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp med tlv-select

Configures the LLDP-MED TLV type to transmit or receive.

Syntax
lldp med tlv-select {network—policy | inventory}
Parameters
  • network-policy — Enable or disable the port description TLV.
  • inventory — Enable or disable the system TLV.
Default
Enabled
Command Mode
INTERFACE
Usage Information
None
Example
OS10(conf-if-eth1/1/3)# lldp med tlv-select network-policy
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\