OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp receive

Enables or disables the LLDP packet reception on a specific interface.

Syntax
lldp receive
Parameters
None
Default
Not configured
Command Mode
INTERFACE
Usage Information
Enable LLDP globally on the system before using the lldp receive command. The no version of this command disables the reception of LLDP packets.
Example
OS10(conf-if-eth1/1/3)# lldp receive
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\