OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp tlv-select basic-tlv

Enables or disables TLV attributes to transmit and receive LLDP packets.

Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-description | system-capabilities | management-address}
Parameters
  • port-description — Enable or disable the port description TLV.
  • system-name — Enable or disable the system TLV.
  • system-description — Enable or disable the system description TLV.
  • system-capabilities — Enable or disable the system capabilities TLV.
  • management-address — Enable or disable the management address TLV.
Default
Enabled
Command Mode
INTERFACE
Usage Information
None
Example
OS10(conf-if-eth1/1/3)# lldp tlv-select basic-tlv system-name
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\