OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp tlv-select dcbxp

Enables and disables DCBX on a port interface.

Syntax
lldp tlv-select dcbxp
Parameters
None
Default
Enabled interface level; disabled global level
Command Mode
INTERFACE
Usage Information
DCBX must be enabled at both the global and interface levels. Enable DCBX globally with the dcbx enable command to activate the exchange of DCBX TLV messages with PFC, ETS, and iSCSI configurations. Use DCBX interface-level commands to configure the TLVs advertised by a DCBX-enabled port, change the DCBX version, or disable DCBX on an interface. The no version of this command disables DCBX on an interface.
Example
OS10(conf-if-eth1/1/1)# lldp tlv-select dcbxp 
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\