OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp tlv-select dot1tlv

Enables or disables the dot.1 TLVs to transmit in LLDP packets.

Syntax
lldp tlv-select dot1tlv { port-vlan-id | link-aggregation}
Parameters
  • port-vlan-id — Enter the port VLAN ID.
  • link-aggregation — Enable the link aggregation TLV.
Default
Enabled
Command Mode
INTERFACE
Usage Information
The lldp tlv-select dot1tlv link-aggregation command advertises link aggregation as a dot1 TLV in the LLDPDUs. The no version of this command disables TLV transmissions.
Example (Port)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv port-vlan-id
Example (Link Aggregation)
OS10(conf-if-eth1/1/3)# lldp tlv-select dot1tlv link-aggregation
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\