OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

lldp transmit

Enables the transmission of LLDP packets on a specific interface.

Syntax
lldp transmit
Parameters
None
Default
Not configured
Command Mode
INTERFACE
Usage Information
The no version of this command disables the transmission of LLDP packets on a specific interface.
Example
OS10(conf-if-eth1/1/9)# lldp transmit
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\