OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

load-balancing

Distributes or load balances incoming traffic using the default parameters in the hash algorithm.

Syntax
load-balancing {ingress-port enable | [tcp-udp-selection l4–destination-port | l4–source-port] | [ip-selection destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–source-port] | [ipv6–selection destination-ip | source-ip | protocol | vlan-id | l4–destination-port | l4–source-port] | [mac-selection destination-mac | source-mac | ethertype | vlan-id]}
Parameters
  • ingress-port enable — Enables load-balancing on ingress ports.
  • tcp-udp-selection — Enables the TCP UDP port for load-balancing configuration.
  • ip-selection — Enables IPv4 key parameters to use in the hash computation.
  • ipv6-selection — Enables IPV6 key parameters to use in hash computation.
  • destination-ip — Enables the destination IP address in the hash calculation.
  • source-ip — Enables the source IP address in the hash calculation.
  • protocol — Enables the protocol information in the hash calculation.
  • vlan-id — Enables the VLAN ID information in the hash calculation.
  • l4-destination-port — Enables the L4 destination port information in the hash calculation.
  • l4-source-port — Enables the L4 source port information in the hash calculation.
  • mac-selection — Enables MAC load-balancing configurations.
  • destination-mac— Enables the destination MAC information in hash the calculation.
  • source-mac— Enables the source MAC information in the hash calculation.
  • ethertype — Enables the Ethernet type information in the hash calculation.
Default
  • ip-selelection—source—ip dest-ip vlan-id l4–source-port l4–dest-port ipv4 protocol
  • ipv6-selection—source—ipv6 dest-ipv6 vlan—id l4–source-port l4–dest-port ipv6 protocol
  • mac-selection—source—mac destination—mac vlan-id ethertype
  • tcp-udp-selection—l4–source-port l4–dest-port
Command Mode
CONFIGURATION
Usage Information
  • IPv4– selection: source-ip destination-ip protocol vlan-id l4-destination-port l4-source-port
  • IPv6 destination address: source-ip destination-ip protocol vlan-id l4-destination-port l4-source-port
  • MAC parameters: source-mac destination-mac ethertype vlan-id
  • TCP/UDP parameters: l4-destination-port l4-source-port

The no version of this command resets the value to the default.

Example (Ingress)
OS10(config)# load-balancing ingress-port enable
Example (IP Selection)
OS10(config)# load-balancing ip-selection destination-ip source-ip
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\