OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

log-adjacency-changes

Enables logging of syslog messages about changes in the OSPFv3 adjacency state.

Syntax
log-adjacency-changes
Parameters
None
Default
Disabled
Command Mode
ROUTER-OSPFv3
Usage Information
The no version of this command resets the value to the default.
Example
OS10(config)# router ospfv3 100
                                       OS10(config-router-ospfv3-100)# log-adjacency-changes
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\