OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

logging server

Configures the remote syslog server.

Syntax
logging server { hostname | ipv4–address | ipv6–address } [severity severity-level | vrf management [severity severity-level]
Parameters
  • hostname | ipv4–address | ipv6–address — (Optional) Enter either the hostname or IPv4/IPv6 address of the logging server.
  • vrf management — (Optional) Configure the logging server for the management VRF instance.
  • severity-level — (Optional) Set the logging threshold severity:
    • log-emerg — System as unusable.
    • log-alert — Immediate action is needed.
    • log-crit — Critical conditions.
    • log-err — Error conditions.
    • log-warning — Warning conditions.
    • log-notice — Normal but significant conditions (default).
    • log-info — Informational messages.
    • log-debug — Debug messages.
Defaults
Log-notice
Command Mode
CONFIGURATION
Usage Information
Starting from 10.3.0E or later, this command supports IPv6 addresses. The previous versions support only IPv4 addresses. The no version of this command deletes the syslog server.
Example
OS10(config)# logging server dell.com severity log-info
OS10(config)# logging server fda8:6c3:ce53:a890::2
OS10(config)# logging server dell.com vrf management severity log-debug
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\