OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

mac access-group

Assigns a MAC access list to an interface.

Syntax
mac access-group access-list-name {in | out}
Parameters
  • access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
  • in — Apply the ACL to incoming traffic.
  • out — Apply the ACL to outgoing traffic.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command resets the value to the default.
Example
OS10(config)# mac access-group maclist in
                                       OS10(conf-mac-acl)#
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\