OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

mac address-table aging-time

Configures the aging time for entries in the L2 address table.

Syntax
mac address-table aging-time seconds
Parameters
seconds — Enter the aging time for MAC table entries in seconds (0 to 1000000).
Default
1800 seconds
Command Mode
CONFIGURATION
Usage Information
Set the aging timer to zero (0) to disable MAC address aging for all dynamic entries. The aging time counts from the last time that the device detected the MAC address.
Example
OS10(config)# mac address-table aging-time 3600
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\