OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

mac address-table static

Configures a static entry for the L2 MAC address table.

Syntax
mac address-table static mac-address vlan vlan-id interface {ethernet node/slot/port[:subport] | port-channel number}
Parameters
  • mac-address — Enter the MAC address to add to the table in nn:nn:nn:nn:nn:nn format.
  • vlan vlan-id — Enter the VLAN to apply the static MAC address to (1 to 4093).
  • interface — Enter the interface type:
    • ethernet node/slot/port[:subport] — Enter the Ethernet information.
    • port-channel channel-number — Enter a port-channel interface number (1 to 128).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The no version of this command resets the value to the default.
Example (VLAN)
OS10(config)# mac address-table static 34:17:eb:f2:ab:c6 vlan 1 interface ethernet 1/1/30
Example (Port-Channel)
OS10(config)# mac address-table static 34:17:eb:02:8c:33 vlan 10 interface port-channel 1
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\