OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Management interface

The Management interface provides management access to the network device. You can configure the Management interface, but the configuration options on this interface are limited. You cannot configure gateway addresses and IP addresses if it appears in the main routing table, and proxy ARP is not supported on this interface.

  1. Configure the Management interface in CONFIGURATION mode.
    interface mgmt 1/1/1
  2. Configure an IP address and mask on the Management interface in INTERFACE mode.
    ip address 
                                           A.B.C.D/prefix-length
                                        
  3. Enable the Management interface in INTERFACE mode.
    no shutdown
Configure management interface
OS10(config)# interface mgmt 1/1/1
                                    OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
                                    OS10(conf-if-ma-1/1/1)# no shutdown
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\