OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Management Route Configuration

  • WARNING: Avoid configuring an IPv4 or IPv6 address and a static route for the management interface that conflict with an IPv4 or IPv6 address and static route on a front-end port interface.
To set up remote access to OS10, configure a management route after you assign an IPv4 or IPv6 address to the Management port. The default management route is the path used by a Management port to communicate with a different network. Management routes are separate from IPv4 and IPv6 routes and are only used to manage the system through the Management port.
management route 192.168.100.0/24 1.1.1.1
                                 ip route 192.168.100.0/24 2.2.2.2
                                 
                                 management route 192.168.200.0/24 managementethernet
                                 ip route 192.168.200.0/24 interface ethernet 1/1/1
                              

Before configuring the static IPv4 address for management interface port, remove the dynamic DHCP setting using the no ip address dhcp command.

Configure a management route to the network from which you access the system in CONFIGURATION mode. Repeat the command to configure multiple routes for the Management interface.
management route {
                                 ipv4-address/mask | 
                                 ipv6-address/prefix-length}  
                                 {
                                 forwarding-router-address | managementethernet}
                              
  • ipv4-address/mask — Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prefix-length format (/ xx).
  • ipv6-address/prefix-length — Enter an IPv6 address in x:x:x:x::x format with the prefix length in /x format (prefix range is /0 to /128).
  • forwarding-router-address — Enter the next-hop IPv4/IPv6 address of a forwarding router for network traffic from the Management port.
  • managementethernet — Configures the Management port as the interface for the route, and forces the route to be associated with the Management interface.

Configure management route

OS10(config)# management route 10.10.20.0/24 10.1.1.1
                              OS10(config)# management route 172.16.0.0/16 managementethernet
                           

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\