OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

management route

Configures an IPv4/IPv6 static route used by the Management port. Repeat the command to configure multiple management routes.

Syntax
management route { ipv4-address/mask | ipv6-address/prefix-length} { forwarding-router-address | managementethernet}
Parameters
  • ipv4-address/mask — Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prefix-length format (/ xx).
  • ipv6-address/prefix-length — Enter an IPv6 address in x:x:x:x::x format with the prefix length in /x format (prefix range is /0 to /128).
  • forwarding-router-address — Enter the next-hop IPv4/IPv6 address of a forwarding router (gateway) for network traffic from the management port.
  • managementethernet — Configure the Management port as the interface for the route; forces the route to be associated with the management interface.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
Management routes are separate from IP routes and are only used to manage the system through the management port. To display the currently configured IPv4 and IPv6 management routes, enter the show ip management-route and show ipv6 management-route commands. Warning: Avoid configuring an IPv4 or IPv6 address and a static route for the management interface that conflict with an IPv4 or IPv6 address and static route on a front-end port interface.
Example (IPv4)
OS10(config)# management route 10.10.20.0/24 10.1.1.1
                                       OS10(config)# management route 172.16.0.0/16 managementethernet
                                    
Example (IPv6)
OS10(config)# management route 10::/64 10::1
Supported Releases
10.2.2E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\