OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

match interface

Configures a filter to match routes whose next-hop is the configured interface.

Syntax
match interface interface
Parameters
interface — Interface type:
  • ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the next-hop interface.
  • port-channel id-number — Enter the port-channel number as the next-hop interface, from 1 to 128.
  • vlan vlan-id —Enter the VLAN number as the next-hop interface, from 1 to 4093.
Default
Not configured
Command Mode
ROUTE-MAP
Usage Information
The no version of this command deletes the match.
Example
OS10(conf-route-map)# match interface ethernet 1/1/1
                                       OS10(conf-if-eth1/1/1)#
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\