OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

match origin

Configures a filter to match routes based on the origin attribute of BGP.

Syntax
match origin {egp | igp | incomplete}
Parameters
  • egp — Match only remote EGP routes.
  • igp — Match only on local IGP routes.
  • incomplete — Match on unknown routes that are learned through some other means.
Default
Not configured
Command Mode
ROUTE-MAP
Usage Information
The no version of this command deletes the match.
Example
OS10(config)# route-map bgp
                                       OS10(conf-route-map)# match origin egp
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\