OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

match precedence

Configures IP precedence values as a match criteria.

Syntax
match [not] {ip | ipv6 | ip-any} precedence precedence-list
Parameters
  • not — Enter to cancel a previously applied match precedence rule.
  • ip — Enter to use IPv4 as the match precedence rule.
  • ipv6 — Enter to use IPv6 as the match precedence rule.
  • ip-any — Enter to use both IPv4 and IPv6 as the match precedence rule.
  • precedence precendence-list — Enter a precedence-list value (0 to 7).
Default
Not configured
Command Mode
CLASS-MAP
Usage Information
You cannot enter two match statements with the same filter-type. If you enter two match statements with the same filter-type, the second statement overwrites the first statement.
Example
OS10(conf-cmap-qos)# match not ipv6 precedence 3
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\