OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

match route-type

Configures a filter to match routes based on how the route is defined.

Syntax
match route-type {{external {type-1 | type-2} | internal | local }
Parameters
  • external — Match only on external OSPF routes. Enter the keyword then one of the following:
    • type–1 — Match only on OSPF Type 1 routes.
    • type–2 — Match only on OSPF Type 2 routes.
  • internal — Match only on routes generated within OSPF areas.
  • local — Match only on routes generated locally.
Default
Not configured
Command Mode
ROUTE-MAP
Usage Information
The no version of this command deletes the match.
Example
OS10(config)# route-map bgp
                                       OS10(conf-route-map)# match route-type external type-1
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\