OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

maximum-paths

Configures the maximum number of equal-cost paths for load sharing.

Syntax
maximum-paths [ebgp number | ibgp number] maxpaths
Parameters
  • ebgp—Enable multipath support for external BGP routes.
  • ibgp—Enable multipath support for internal BGP routes.
  • number —Enter the number of parallel paths, from 1 to 64.
Default
64 paths
Command Mode
ROUTER-BGP
Usage Information
Dell EMC recommends not using multipath and add path simultaneously in a route reflector. To recompute the best path, use the clear ip bgp * command. The no version of this command resets the value to the default.
Example (EBGP)
OS10(conf-router-bgp-2)# maximum-paths ebgp 2 maxpaths
Example (IBGP)
OS10(conf-router-bgp-2)# maximum-paths ibgp 4 maxpaths
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\