OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

maximum-prefix

Configures the maximum number of prefixes allowed from a peer.

Syntax
maximum-prefix { number [ threshold] [warning]}
Parameters
  • number —Enter a maximum prefix number, from 1 to 4294967295.
  • threshold —(Optional) Enter a threshold percentage, from 1 to 100
  • warning-only — (Optional) Enter to set the router to send a log message (warning) when the maximum limit is exceeded. If you do not set this parameter, the router stops peering when the maximum prefixes limit exceeds.
Default
75% threshold
Command Mode
ROUTER-BGP-NEIGHBOR-AF
Usage Information
If you configure this command and the neighbor receives more prefixes than the configuration allows, the neighbor goes down. To view the prefix information, use the show ip bgp summary command output. The neighbor remains down until you use the clear ip bgp command for the neighbor or the peer group to which the neighbor belongs. The no version of this command resets the value to the default.
Example
OS10(conf-router-bgp-neighbor-af)# maximum-prefix 20 100 warning-only
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\