OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

monitor session

Creates a session for monitoring traffic with port monitoring.

Syntax
monitor session session-id type [local | rspan-source | erpm-source ]
Parameters
  • session-id — Enter a monitor session ID (1 to 18).
  • local — (Optional) Enter a local monitoring session.
  • rspan-source — (Optional) Enter a remote monitoring session.
  • erpm-source — (Optional) Enter an encapsulated remote monitoring session.
Default
local
Command Mode
CONFIGURATION
Usage Information
The no version of this command removes the monitor session.
Example
OS10(config)# monitor session 1
                                       OS10(conf-mon-local-1)#
                                       
                                    
Example (RPM)
OS10(config)# monitor session 5 type rspan-source
                                       OS10(conf-mon-rspan-source-5)#
                                       
                                    
Example (ERPM)
OS10(config)# monitor session 10 type erpm-source
                                       OS10(conf-mon-erpm-source-10)#
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\