OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

name

Configures a descriptive name for the uplink-state group.

Syntax
name string
Parameters
string — Enter a description for the uplink-state group. A maximum of 32 characters.
Default
Not configured
Command Mode
UPLINK-STATE-GROUP
Usage Information
The no version of this command removes the descriptive name.
Example
OS10(config)# uplink-state-group 1
                                       OS10(conf-uplink-state-group-1)# name test_ufd_group
                                    
Supported Releases
10.4.0E(R3) or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\