OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

neighbor

Creates a remote peer for the BGP neighbor and enters BGP Neighbor mode.

Syntax
neighbor ip address
Parameters
ip address — Enter the IP address of the neighbor in dotted decimal format.
Default
Not configured
Command Mode
CONFIG-ROUTER-BGP
Usage Information
Create a remote peer with the BGP neighbor. Always enter the IP address of a BGP peer with this command. The command does not validate if the configured peer address is a local IP address. The no version of this command disables the BGP neighbor configuration.
Example
OS10(conf-router-bgp-2)# neighbor 32.1.0.0
                                       OS10(conf-router-neighbor)# 
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\