OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Network policy advertisement

LLDP-MED is enabled on all interfaces by default. Configure OS10 to advertise LLDP-MED TLVs out of configured interfaces. Define LLDP-MED network policies before applying the policies to an interface. Attach only one network policy per interface.

  • Define an LLDP-MED network-policy on an interface in CONFIGURATION mode.
    lldp-med network-policy {add | remove} 
                                           number
                                        
    • add — Attach the network policy to an interface.
    • remove — Remove the network policy from an interface.
    • number — Enter a network policy index number (1 to 32).
Configure advertise LLDP-MED network policies
OS10(conf-if-eth1/1/5)# lldp-med network-policy add 1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\