OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

network

Configures a range of IPv4 or IPv6 addresses in the address pool.

Syntax
network address/mask
Parameters
address/mask — Enter a range of IP addresses and subnet mask in A.B.C.D/x or A::B/x format.
Default
Not configured
Command Mode
DHCP-POOL
Usage Information
Use this command to configure a range of IPv4 or IPv6 addresses.
Example
OS10(config-dhcp-Dell)# network 20.1.1.1/24
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\