OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ntp authenticate-key

Configures the authentication key for trusted time sources.

Syntax
ntp authenticate-key number md5 [0 | 7] key
Parameters
  • number — Enter the authentication key number (1 to 4294967295).
  • md5 — Set to MD5 encryption.
  • 0 — Set to unencrypted format (default).
  • 7 — Set to hidden encryption.
  • key — Enter the authentication key.
Default
0
Command Mode
CONFIGURATION
Usage Information
The authentication number must be the same as the number parameter configured in the ntp trusted-key command. Use the ntp authenticate command to enable NTP authentication.
Example
OS10(config)# ntp authentication-key 1200 md5 0 dell
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\