OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ntp disable

By default, NTP is enabled on all interfaces. Prevents an interface from receiving NTP packets.

Syntax
ntp disable
Parameters
None
Default
Enabled
Command Mode
INTERFACE
Usage Information
This command is used to configure OS10 to not listen to a particular server and prevents the interface from receiving NTP packets. The no version of this command re-enables NTP on an interface.
Example
OS10(conf-if-eth1/1/7)# ntp disable
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\