OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ntp server

Configures an NTP time-serving host.

Syntax
ntp server { hostname | ipv4-address | ipv6-address} [key keyid] [prefer]
Parameters
  • hostname — Enter the host name of the server.
  • ipv4–address | ipv6–address — Enter the IPv4 address (A.B.C.D) or IPv6 address (A::B) of the NTP server.
  • key keyid — (Optional) Enter the NTP peer key ID (1 to 4294967295).
  • prefer — (Optional) Configures this peer to have priority over other servers.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
You can configure multiple time-serving hosts. From these time-serving hosts, the system chooses one NTP host to synchronize with. To determine which server to select, use the show ntp associations command. Dell EMC recommends limiting the number of hosts you configure, as many polls to the NTP hosts can impact network performance.
Example
OS10(config)# ntp server eureka.com
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\