OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

ntp trusted-key

Sets a key to authenticate the system to which NTP synchronizes with.

Syntax
ntp trusted-key number
Parameters
number — Enter the trusted key ID (1 to 4294967295).
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
The number parameter must be the same number as the number parameter in the ntp authentication-key command. If you change the ntp authentication-key command, you must also change this command. The no version of this command removes the key.
Example
OS10(config)# ntp trusted-key 234567
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\