OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

OS9 environment commands

You can configure commands in an OS9 environment by using the feature config-os9-style command. The current release supports VLAN tagging and port-channel grouping commands.
  • VLAN Interface mode
    • tagged
    • no tagged
    • untagged
    • no untagged
  • Port-channel Interface mode:
    • channel-member
    • no channel-member
  • Enable the feature to configure commands in an OS9 environment in CONFIGURATION mode.
    OS10(config)# feature config-os9-style
                                        OS10(config)# exit
                                        OS10# show running-configuration compressed 
                                        interface breakout 1/1/28 map 10g-4x
                                        feature config-os9-style
                                     
  • Once this feature is enabled, you cannot use the OS10 format of commands in the new session.
    OS10(config)# interface vlan 11
                                        OS10(conf-if-vl-11)# tagged ethernet 1/1/15 
                                        
                                        OS10(conf-if-vl-11)# show configuration
                                        !
                                        interface vlan11
                                        no shutdown
                                        tagged ethernet 1/1/15
                                     

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\