OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

Packet timer values

LLDPDUs are transmitted periodically. You can configure LLDP packet timer values for LLPDU transmission.

  1. Configure the LLDP packet timer value in CONFIGURATION mode.
    lldp timer
  2. Enter the multiplier value for the hold time in CONFIGURATION mode.
    lldp holdtime-multiplier
  3. Enter the delay (in seconds) for LLDP initialization on any interface in CONFIGURATION mode.
    lldp reinit

Configure LLDPDU timer

OS10(config)# lldp timer 60
                                 OS10(config)# do show lldp timers
                                 LLDP Timers:
                                 Holdtime in seconds: 120
                                 Reinit-time in seconds: 2
                                 Transmit interval in seconds: 60
                              

Configure LLDPDU intervals

OS10(config)# lldp holdtime-multiplier 2
                                 OS10(config)# do show lldp timers
                                 LLDP Timers:
                                 Holdtime in seconds: 60
                                 Reinit-time in seconds: 2
                                 Transmit interval in seconds: 30
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\