OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

permit ipv6

Configures a filter to permit all or specific packets from an IPv6 address.

Syntax
permit ipv6 [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | count bytes | dscp | fragment]
Parameters
  • A::B — (Optional) Enter the source IPv6 address from which the packet was sent and the destination address.
  • A::B/x — (Optional) Enter the source network mask in /prefix format (/x) and the destination mask.
  • any — (Optional) Set all routes which are subject to the filter:
    • capture — (Optional) Enter to capture packets the filter processes.
    • count — (Optional) Enter to count packets the filter processes.
    • byte — (Optional) Enter to count bytes the filter processes.
    • dscp value — (Optional) Enter to deny a packet based on the DSCP values, from 0 to 63.
    • fragment — (Optional) Enter to use ACLs to control packet fragments.
  • host ipv6–address — Enter the IPv6 address to use a host address only.
Default
Not configured
Command Mode
IPV6-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter.
Example
OS10(conf-ipv6-acl)# permit ipv6 any any count capture session 1 
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\