OS10 Enterprise Edition User Guide Release 10.4.0E(R3)

PDF

police

Configures traffic policing on incoming traffic.

Syntax
police {cir committed-rate [bc committed-burst-size]} {pir peak-rate [be peak-burst-size]}
Parameters
  • cir committed-rate — Enter a committed rate value in kilo bits per second (0 to 4000000).
  • bc committed-burst-size — (Optional) Enter committed burst size in packets for control plane policing and in KB for data packets. (16 to 200000).
  • pir peak-rate — Enter a peak-rate value in kilo bits per second (0 to 40000000).
  • be peak-burst-size — (Optional) Enter a peak burst size in kilo bytes (16 to 200000).
Defaults
  • bc committed-burst-size value is 200 KB for control plane and 100 KB for all other class-map types
  • be peak-burst-size value is 200 KB for control plane and 100 KB for all other class-map types
Command Mode
POLICY-MAP-CLASS-MAP
Usage Information
If you do not provide the peak-rate pir values, the committed-rate cir values are taken as the pir values. Only the ingress QoS policy type supports this command. For control-plane policing, the rate values are in pps.
Example
OS10(conf-pmap-c-qos)# police cir 5 bc 30 pir 20 be 40
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\